What's the difference between relay and direct antennas? :: Kerbal The only important thing is that the orbital periods of all three be the same, as the larger the difference, the sooner they will get out of position. Polar triangle orbit above 600km. I tried launching one satellite every 46 days, but that didn't work. Kerbin has done a portion t/k of its orbit, which corresponds, for a satellite on target orbit, of a advance of t2 = p*t/k. I suppose I could launch all of my satellites at (about) the same time (they're too big to practically launch as a single vessel especially eight of them) and use the calculator to space them out. 2 identical dishes have a power of 1.68 times a single dish, and 4 dishes have a power of 2.8 times a single dish. Use RA-100 relays. I basically do what @Geonovast posted. Use RA-2 relays. Polar triangle orbit above 60km. Such a formation will provide coverage on all of Kerbin's surface and cannot get fully occluded by Mun/Minmus. Has depleted uranium been considered for radiation shielding in crewed spacecraft beyond LEO? To subscribe to this RSS feed, copy and paste this URL into your RSS reader. This can be easily solved with the addition of one more satellite (at a later point), just make sure no two satellites line up when Kerbin blocks one of them. Let's say p is the period of your target orbit and k the period of Kerbin orbit. The transmission would be 13 packets and consume 78 in 7.8 seconds. 8 direct antennas therefore, will then double communication range for transmitting data. A steep launch requires fewer RemoteTech-specific skills but is less efficient (and may lead to a broken rocket while playing FAR), while the flight computer gives you the freedom to build and launch your rocket how you like but requires you to pick up more advanced skills right away. Polar triangle orbit above 320km. Upload or insert images from URL. About 3000g orbiting outside Minmus. An elliptical orbit might be better if you want to do it with one sat, but then you'd have to adjust orbit every once in a while to have the AP above your base/probe/rover. Satellites are not connecting to each other :: Kerbal Space Program You then need to have (for 8 satellites) p/8 = t*(p/k - 1) with t the time between launches. Some trial and error may be necessary if youre used to shallower launches, but the traditional 45 ascent path should work. Stack Exchange network consists of 181 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers. KerbalX - KSP Craft Sharing Simplified [1.3, 1.4, 1.5, 1.6, 1.7, 1.8+] Contract Pack: CommNet Relays 2.1.0 If not, is there a mod or config option to make folding antennas work as relays? Your previous content has been restored. These relays are for connecting with deep space probes. So how do you launch and control the very satellites that are supposed to help you do the controlling? (The "line up" will happen if, and only if, the phase angle differences between any one satellite, and any two other satellites adds up to somewhere near 180 degrees. Use RA-2 relays. Communication links only work while the satellite has power, so if you fail to deploy the panels before the satellite goes out of contact, you might not be able to recover it one orbit from now. That gives an orbital period of roughly 184 days. Of course if you want to place your satellites evenly on the same orbit as they already are, without fiddling with temporary elliptical orbits, then they'll just stay right where they are for eternity And since I did not test all of this and could have made a huge and humiliating mistake, please tell me if your tests prove me right ! Of course the trouble in KSP doesn't have Lagrange points (which is what Queqiao . The large solar panels sort of look like Gigantor arrays maybe on pipes or actuators? Not to mention transmitting grav scans for every biome! they have have antenna extended and are in range but their not bouncing back signals to get full conection. So I am trying to build an efficient network of relay satellites to allow me to communicate with spacecraft exploring the far sides of the Mun and Minmus. A second equatorial triangle orbit at around 300,000km. Calculate Satellite Constellation Launch Interval, Improving the copy in the close modal and post notices - 2023 edition, New blog post from our CEO Prashanth: Community is the future of AI, Screenshot of the Week #89 [Submissions Closed, Vote Now!]. Click GRD+ to tell the ship to face prograde (at least, until it gets out of the atmosphere), then click EXEC to tell it to execute the maneuver node. is there such a thing as "right to be heard"? Relay sat. Let's try it for your first constellation : Period of target orbit p = 184 days. All trademarks are property of their respective owners in the US and other countries. Circular orbit - Just easier to work with (and to do the math). load your currently installed mods. Rather than opening instantly, the solar panels will appear in the queue, scheduled to open after the delay. Your second probe might have some visual mods, or maybe some custom dish parts because I don't see a stock dish that looks exactly like those dishes do Ditto your forward solar panels; they either look like custom textures for the 3x2 stock panel, or custom parts. Add a relay satellite on the top ( RA-2, RA-15, or RA-100, depending on range) Done! Suppose you want to put three relay satellites into circular polar orbit around Minmus. All RemoteTech antennas are safe to use above 35 km, so you should be able to deploy the antenna while still in line of sight to KSC. Multi-Satellite Launches - Kerbal Space Program Forums > With proper resonance, you are in a mapping orbit and can complete grab/temp scans above x contacts without fuel burn. I want to send a probe to Eve as this is my first planetary mission and I'd rather not risk kerbals.
1913 Patton Sword For Sale, Articles K